17
www.behnke-online.com
Instructions Camera Modules
Camera featuring LED illumination
GB
3.1. General Information
The following article numbers all describe the
present camera module with LED illumination:
20-2903, 20-9562, 21 -2903 and 50-2903. The
camera installation is fixed and it cannot be
moved. The angle of view is 80°. It is possible
to install the camera to a detached electronics
system. The use of the camera requires a power
supply unit (article no. 20-9585).
Video signal CVBS with detached electronics installation (connection to clamps Video/
Mass on the basic electronics optional, please note: Does not enable a simultaneuous
operation of receiver stations / display devices.)
Wire link illumination on/off (in default settings: on)
Camera circuit
Camera mounting
(static camera)
12 - 15 V= with detached
electronics installation
(connection optional,
please observe the gal-
vanic isolation towards
the basic electronics)
3.
camera featuring leD illumination
3.2. Technical Specifications
▸
1/4" Sony CCD-Chip
▸
Horizontal resolution 480 TVL
▸
Video mode PAL, CVBS (1Vss)
▸
Integrated lens, focal length 2.5 mm
▸
Minimal illumination 1.5 Lux / F 1.4
▸
Electronic shutter control (ESC)
▸
Automatic Backlight Control (BLC)
▸
Automatic Gain Control (AGC)
▸
Angle of view 80° (fix)
▸
Max. reach of video signal 100 m with a
coaxial connection or a shielded and twisted
two-core connection. The video connection
must be free from any stray radiation.
