Speed Dial
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
58
UST DK Electronic Telephone
Speed Dial
Speed Dial enables you to call a telephone number with a two- or three-digit access code.
There are two types of Speed Dial numbers:
♦
Station—assigned by individual station users to their own station and can only be dialed
from the station that assigns it.
♦
System—assigned only from attendant consoles or a designated station (typically the
System Administrator station), and can be used by other stations. (See System
Administrator User Guide for storing instructions.)
Important!
If you do not perform the following procedures within a specified time (set in
system programming for either one or three minutes) when storing speed dial
numbers, the operation times out and your telephone returns to idle mode.
➤
To store/replace a telephone number on a Station Speed Dial button
2. Speak at a normal
voice level toward the
telephone.
3. Press
(
to
disconnect the call.
1. Press
"
(or
) with
the handset on-hook.
2. Press
"
to store the
telephone number on
"
buttons are assigned in system programming.
...or
"
(or
) and
enter the Speed Dial
code that you want to
use for the telephone
number
See Table 32 on Page 102—Speed Dial Access Codes.
3. Enter the telephone
number (max. 20
digits).
To store longer dialing strings, see “Speed Dial Number
Linking” on Page 62. To insert a pause or flash signal in the
number, see “Speed Dial Pause” on Page 62.
4. Press
"
(or
)
The number is stored.
