Call Forwarding
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
32
UST DK Electronic Telephone
Call Forward Remote Destination Change
If Call Forward-External mode is set at your station, you can change the forwarding
destination from a telephone outside of the system.
➤
To change the destination number from outside your system
1. Call into the DK
system over a CO
Line programmed for
the DISA feature.
You hear ringback tone signal, then internal dial tone for 10
seconds.
Try again if you hear busy tone.
Note
See the System Administrator for DISA telephone
numbers.
2. Press
&
then dial
your [PDN] after you
receive dial tone.
You hear a confirmation tone.
If a number is not dialed, the system automatically makes the
DISA CO Line ring as a normal incoming call. Then, if the call
is not answered within 15 seconds after the ringing starts, it
disconnects.
3. Enter the Remote Call
Forward-External
security code.
You hear a confirmation tone. See the System Administrator
for the security code which is assigned to your telephone in
system programming.
4. Enter the new
destination number.
You can enter an
internal number,
Voice Mail number, or
a CO Line access
code plus an external
telephone number.
With some systems,
you can dial a line
group code instead of
a CO Line number
access code. (See
Appendix A, Table 29
on Page 100.)
Notes
●
LCR access code “9” cannot be used as the CO Line access
code.
●
When entering CO line access codes (
333
), enter
333
instead of
333
.
5. Press
.
You hear a confirmation tone.