End user instructions
│
T9/T11
│
Chapter 6: Operation
6.5 S tart a session (no PIN code)
To be able to control a receiver with the transmitter, the transmitter must be
registered in the receiver
. If no receiver is registered, the display will show
[No
receivers][Press Menu + Stop]
after the stop button has been pulled out.
When not in use, transmitters must be switched off and stored in a
secure storage space.
Do not use the system if the stop button is damaged or if it does not
stop the equipment. Doing so could result in serious injury or death.
NOTE: If no action is taken within 3 minutes after the
Stop
button has been
released, the transmitter will turn off. Press the
Stop
button before making a new
attempt to start the transmitter.
NOTE: The last accessed receiver(s) will automatically be selected the next time
the transmitter is started.
1. Make sure that the
Stop
button is pressed.
2. Twist and release the
Stop
button.
The top LED lights. The receiver(s) selected in the last session are indicated
by the corresponding red lit LED.
T9
:
The display shows:
[Start by pressing 5+6]
;
T11:
The display shows:
[Start by pressing 9+10]
.
Go to step 4 to log in to the previously selected receiver, go to step 3 to
select another receiver.
If no receiver is selected, the red LEDs for all available receivers will flash
and the display will show
[Select receiver(s)]
.
3. Press the button(s) corresponding to the receiver(s) to operate.
The respective red LEDs stop flashing and remain lit.
The display shows:
T9:
The display shows:
[Start by pressing 5+6]
;
T11:
The
display shows:
[Start by pressing 9+10]
.
To cancel, press the same button(s) again. The corresponding red LEDs start
flashing and the display shows
[Select receiver(s)]
.
4. Press and hold both
Start
buttons simultaneously.
The buzzer emits a beep.
22
ED-TG2-TX102-EN-v02
