Tele Radio R2-01, Installation Instructions Manual, Page: 29 / 38

Installation instructions
│
R2
│
Annex A: Implementation Specifications – Lynx (in
English)
ANNEX A: IMPLEMENTATION SPECIFICATIONS –
LYNX (IN ENGLISH)
A.1 M odbu s C ommands
Function Sub-function Function name
3 0x03 Read Holding Registers
4 0x04 Read Input Registers
(Equivalent to Read Holding Registers)
16 0x10 Write Multiple Registers
17 0x11 Report Slave ID
22 0x16 Mask write Register
65 0x41 Tele Radio – Event management
0x01 – Poll Events
0x02 – Delete Events
0x03 – Respond to Event
66 0x42 Tele Radio – Transmitter management
0x01 – Get total number of transmitters
0x02 – Get transmitter Ids
0x03 – Delete all transmitters
0x04 – Add one transmitter by ID
0x05 – Enter Learn mode
67 0x43 Tele Radio – Interrupt (Not implemented)
0x01 – Change interrupt
A.2 Register M ap
Changes to registers will be applied directly after a Modbus response has been sent
from the slave. I.e. if new serial setting is written to 0x0001 by the master, the slave
(Lynx) will change to the new serial setting directly after it has sent its response.
Address Contents
0x0000 Status register
0x0001 Reserved
0x0002 Reserved
0x0003 RS232 Modbus address (default 0x66 )
IM-LX-RX101-EN-v01 29