Fig. 11:
LAN switch ports
Note
Only the LAN 1 connector is available during booting and in BIOS mode.
3.7.2 WAN connections
The RS1800 series has 4 Ethernet interfaces for WAN connection. These ports have 2 connectors - SFP for an op-
tical link and RJ45 for a 10/100/1000 Base-T link - but they cannot work simultaneously. These interfaces are totally
independent from the switch and are handled like every other interface.
Please pay careful attention to the labeling to avoid mistaking these ports for other types of ports:
Fig. 12:
WAN connectors
Note
WAN connectors do not work during booting and in BIOS mode.
3.7.2.1 Laser information
Choose SFP transceivers that meet the following regulations
• Class 1
• IEC/EN60825-1:2007 2nd Edition or a later one, European standard
• FCC 21 CFR Chapter 1, Subchapter J (in accordance with FDA and CDRH re-
quirements)
• Application of CE marking in accordance with the 2014/30/EU EMC Directive
and the 2014/35/EU Low Voltage Directive
• UL and/or CSA registered component for North America
• 47 CFR Part 15, Class A
Warning
Laser Radiation. Do not use optical instruments directly or without proper protection. CLASS 1 LASER
PRODUCT.
The SFP modules to be installed in the card socket should be class 1 devices that comply with the IEC/
EN 60825-1:2007 standard.
3.7.3 WWAN antenna connection (cell connector)
The RS1800 series has two connectors for WWAN antennas in the rear panel and two connectors for WWAN anten-
nas in the side panels (on -4G models).
Teldat S.A.
3 Components and Power Supply
RS1800 series
15
