• Power: 9W
• LAN: RJ45 connector will support IEEE802.3 Ethernet over copper wiring standards of 10Base-T, 100Base-TX,
and1000Base-T
• WAN: Gigabit Ethernet Combo RJ45+SFP connector:
• RJ45 connector will support IEEE802.3 Ethernet over copper wiring standards of 10Base-T, 100Base-TX,
and1000Base-T.
• SFP port will support 1000Base-X Fiber Ethernet standard SFP.
• Serial Ports.
• 1xRJ45 connector RS-232 port (DCE).
• 2xRJ45 connectors for RS-232 port (DCE) and/or RS-485 (2/4 wires). Its availability requires one additional ac-
cessory.
• WWAN: Depending on the model. ("L" models)
• 1xLTE Category 4 WWAN module with two SMA connectors.
• 2 Intenal SIM trays with 2FF form factor.
• External Reset/Recovery push button
2.4 Components
2.4.1 Front Panel
The front panel includes the status LEDs.
The following figure shows the front panel.
Fig. 3:
Front Panel
While the device is in startup mode, LED L lights up in green. Once the device has started up, the LEDs indicate the
following:
Table 2: LEDs
LED
Associated Inter-
face
Status
Description
ON
Power
Off
Green
Device is not powered on.
Device is powered on.
P
PLC interface
Off
PRIME PLC interface is disabled, unavailable or not installed.
PRIME PLC is running but no SNs are currently detected.
Teldat S.A.
2 Product Overview
Regesta Smart PLC
7
