strange characters appear in the answers you get.
connected.
Check that you don't have two MTC+ with the same ID.
Check the management interface connec-
tions(input/output).
Press the Reset Button for all MTC+.
You hear a constant noise and the Control LED blinks
permanently.
Disconnect the MTC+.
Check that the input power voltage (110 or 220 V)
matches your model.
When you run list, the devices that appear to be connec-
ted are not the ones you actually have.
Check the management interface connec-
tions(input/output).
Check you don't have two MTC+ with the same ID.
Check the management interface connec-
tions(input/output).
Check the main power connectors for all MTC+.
Press the Reset Button for all MTC+.
Warning
• Do not handle or carry out any type of maintenance or inspection operation on the MTC+ when this is
connected to the main power supply.
• Should the fuse need to be substituted, you MUST physically disconnect the device from the main
electricity supply and from all other devices and/or equipment. Only qualified personnel should re-
place the fuse. Only use a fuse of the same electronic characteristics, which is correctly homolog-
ated.
Fig. 7: Fuse replacement.
A.2 Connectors
Technical Information
Teldat S.A.
12
MTC+
