To avoid electric shocks, residual current circulation, and other unwanted effects that also affect communications, the
following is recommended:
WARNING: All interconnected communication devices should be plugged to THE SAME GROUNDED POWER
OUTLET, which should, at the same time, be of good quality (lower than 10 ohms).
Whether the workplace is provided with an uninterrupted power supply system (UPS), regulated supply, or it is inde-
pendent from the rest (such as lighting, etc.), we highly recommend connecting all data devices to the same power
source. This will help prevent drivers and other components from aging prematurely and displaying other operating
problems.
3.3.2 PoE
Fig. 11: Diagram to connect the PoE adapter to the router
The Teldat Connect-4GE can be powered through an Ethernet cable, provided it complies with the POE 802.3aF
standard. The ETHERNET port is enabled for this.
To connect the Ethernet cable with PoE power to the router, please carry out the steps included in the
on page 11.
Figure 11 illustrates how to connect the PoE injector to the device.
3.3.3 Connecting to the power source
3.3.4 Connect
3.3.4.1 If the Ethernet cable isn’t PoE
• Make sure that the router’s power switch is in the OFF position (0).
• Make sure the power supply is NOT connected to the electricity or the router.
• Connect all data cables.
• Connect the power supply cable to the device.
• Connect the power supply cable to the electricity supply.
• Change the router’s power switch to the ON position (1).
3 Components and Power Supply
Teldat S.A.
10
Teldat Connect-4GE Router
