elmeg IP140 / en / elmeg140_v1 / starting.fm / 09.04.2014
V
e
rsion 2, 27.0
5
.2010
15
elmeg IP140
bintec elmeg
First steps
Connecting the network cable
To make calls via VoIP, your phone must have Internet access. This connection is established in
the local network via a gateway.
You connect your phone to the same local network as the gateway. See the
section on
for an overview of the different options.
§§1§§
Attach one end of the Ethernet cable supplied to the right-hand LAN port on the
rear of the phone.
§§2§§
Attach the other end of the Ethernet cable to a LAN port on your network Ethernet
switch or on the router itself.
An Ethernet cable is not required if you connect your phone to the local network using WLAN.
However, we recommend that you use a cable the first time you establish a connection.
Warning
If you connect your elmeg IP140 to a PoE-capable Ethernet switch (PoE class IEEE802.3af ), it will
be supplied with power via PoE (Power over Ethernet). The PoE network must not exceed the
premises boundaries.
2
1
