6
Installation Guide
A device that is wired straight through needs one crossover connection:
If the cable is…
straight through
crossover
… the MDI-II to MDI-X Switch Setting should be
X
II
A device that is wired crossover needs a parallel connection:
If the cable is…
straight through
crossover
… the MDI-II to MDI-X Switch Setting should be
II
X
• The parallel symbol (
II
) indicates a straight through or parallel connec-
tion. Switch is out.
(default)
• The cross symbol (
X
) indicates a crossover connection. Switch is in.
Use the tables below as a guide.
Figure 1.
DIP Switches
The 10/100 AutoTwister includes a set of six DIP switches located on the
) These switches allow you to select the
operational mode best suited to your network’s configuration.
When setting DIP switches, the ON position is when the DIP switch is
pushed up toward the top of the unit. The OFF position is when the DIP
switch is pushed down toward the bottom.
