GW-483S Installation Guide
Rev. B
Repeat for the bottom hinges.
4.
With the top/bottom hinges aligned, gently push the enclosure against the
cabinet until the enclosure snaps into its place.
5.
The enclosure should now freely swing open/closed to expose/cover the
technician’s area of the cabinet.
Top
Hinge
Bottom
Hinge
Unpopulated
SFP Cage
Enclosure
Locking
Screw
RF Board
Mechanical
Alignment
Slot
Terminal
Bridge
Assembly
Holder
Figure 5: The VoIP Gateway Board Enclosure – Top View
Cable Connections
This section describes the connection of the wiring needed to connect the cabinet to the
subscriber’s home.
Connecting the Internal Fiber Cable to the Gateway Board
1.
Open the enclosure to expose the technician’s area and to gain access to the
gateway board connectors (see .
2.
Plug one end of the internal fiber cable into the “ELECTRONICS IN” side
of the connector interface (see
), then plug the other end into the
SFP tranceiver.
Installing the GW-483S
15