Getting Started
Connecting Power
AC Adapter
The instrument operates from an external AC adapter with a line frequency of 50
or 60 Hz, over the range of 100-240 Volts, without the need for con
fi
guration,
except the power cord. The typical power draw is 22 Watts. Refer to the
WVR5200 Speci
fi
cations and Performance Veri
fi
cation Technical Reference
on the Product Documentation CD for additional information on power and
environmental requirements.
Power-On
1.
Connect the supplied power cord to the rear-panel power connector.
2.
Press the power button on the instrument front-panel and the instrument will
turn on.
NOTE.
The Standby button on the front-panel does not disconnect mains power.
Only the power cord at the rear of the product can disconnect mains power. Make
sure that the power cord is accessible when the product is operating.
Power-Off
1.
Press the power button on the instrument front-panel to turn the instrument off.
2.
To remove power completely, disconnect the power cord from the rear-panel
of the instrument.
Network Installation
After your instrument is physically installed, you might want to connect it directly
to a PC and a network. The following information can help you do that.
See the
WVR5200 Installation and Safety Instructions
that shipped with your
instrument for basic installation instructions.
If you are installing this instrument into a system, see the
WVR5200 System
Integration Technical Reference
for installation instructions.
Connecting Directly to a
PC
The following procedure will help you connect your instrument to a PC:
1.
Connect the instrument directly to a PC with an Ethernet cable. The instrument
has an auto-crossover feature. You can also use a HUB. (See Figure 1.)
2.
Set up the instrument as described in the following procedures, choosing
Manual IP mode to set the IP address manually. Be sure to set an address that
is compatible with the setting of your PC.
3.
If you are using an SNMP setup, use the SNMP setup procedure.
WVR5200 Waveform Rasterizer User Manual
5
Summary of Contents for WVR5200 Series
