Checking Chroma/Luma Delay (Lightning Display)
The Lightning display can be used for interchannel timing measurements. If the
color-difference signal is not coincident with luma, the transitions between the
color dots will deviate from the center mark of a delay scale. The amount deviated
represents the relative signal delay between luma and the color-difference signal.
1.
Connect a signal containing color bar information to an input on the rear panel.
2.
Select a tile to view the Lightning Display, then press and hold the
VECTOR
button.
3.
In the Vector pop-up menu, select
Lightning
for the
Display Type
.
4.
Set
Bar Targets
to match your input signal.
5.
Select
Center Waveform
and press the
SEL
button to center the waveform.
6.
Press the
VECTOR
button to close the pop-up menu.
7.
Determine where transitions intersect the delay scales and derive the timing
error in nanoseconds, as de
fl
ected from the center mark, using the following
guidelines. (See Figure 45.)
The center mark of the nine marks spanning each green-magenta transition
is the zero error point.
Alignment to a mark toward black means the color-difference signal lags
with respect to luma.
Alignment to a mark toward white means the color-difference signal leads
the luma signal.
The upper half of the display measures the Pb to Y timing; the bottom
half measures the Pr to Y timing.
WVR5200 Waveform Rasterizer User Manual
95
Summary of Contents for WVR5200 Series
