Appendix A: TPS2000B Speci
fi
cations
All speci
fi
cations apply to the TPS2000B series oscilloscopes. TPP0101 and
TPP0201 probe speci
fi
cations appear at the end of this chapter. To verify that the
oscilloscope meets speci
fi
cations, the oscilloscope must
fi
rst meet the following
conditions:
The oscilloscope must have been operating continuously for twenty minutes
within the speci
fi
ed operating temperature.
You must perform the Do Self Cal operation, accessible through the Utility
menu, if the operating temperature changes by more than 5 °C (9 °F ).
The oscilloscope must be within the factory calibration interval.
All speci
fi
cations are guaranteed unless noted “typical.”
Oscilloscope Speci
fi
cations
Table 1: Acquisition Speci
fi
cations
Characteristics
Description
Acquisition Modes
Sample, Peak Detect, and Average
Acquisition Rate, typical
Up to 180 waveforms per second, per channel (Sample acquisition mode, no measurements)
Acquisition Mode
Acquisition Stops After
Sample, Peak Detect
Single acquisition, all channels simultaneously
Single Sequence
Average
N acquisitions, all channels simultaneously, N is selectable
from 4, 16, 64, and 128
Table 2: Input Speci
fi
cations
Characteristics
Description
Input Coupling
DC, AC, or Ground
Input Impedance, DC Coupled
1 M
Ω
±2% in parallel with 20 pF ±3 pF
Overvoltage Category
Maximum Voltage
CAT II
300 V
RMS
Maximum Voltage Between
Signal and Reference at input
BNC
1
Derate at 20 dB/decade above 100 kHz to 13 V peak AC at 3 MHz and above. For non-sinusoidal
waveforms, peak value must be less than 450 V. Excursion above 300 V should be less than
100 ms duration. RMS signal level including any DC component removed through AC coupling
must be limited to 300 V. If these values are exceeded, damage to the instrument may result.
Refer to the Overvoltage Category description.
Maximum Voltage Between
BNC Reference and Earth
Ground
1
600 V
RMS
CAT II, using rated connectors or accessories
TPS2000B Series Digital Oscilloscope User Manual
123
Summary of Contents for TPS2012B
