Tektronix TLA7000 Series, Installation Manual

Page: 28 / 121

Basic Installation
The following addresses are available and displayed sequentially, beginning with
the DHCP selection:
Table 3: Preset IP addresses
Selection IP address Subnet mask
Default
gateway
Comments
Use: DHCP
– – –
IP addressing provided by a DHCP-capable router
Use:
169.254.0.19 169.254.0.19 255.255.0.0 0.0.0.0 Static, non-routable address used for direct PC
connection
Use:
169.254.0.20 169.254.0.20 255.255.0.0 0.0.0.0 Static, non-routable address used for direct PC
connection
Use:
192.168.0.19 192.168.0.19 255.255.0.0 0.0.0.0 Static, non-routable address used for private LAN
with DHCP-capable router
Use:
192.168.0.20 192.168.0.20 255.255.0.0 0.0.0.0
Static, non-routable address used for private LAN
with DHCP-capable router
Factory default
– – –
Return to factory settings (Use DHCP and restore
default Host Name to TLA7016_<Mainframe S/N>)
No change
– – –
Retain current IP address and Host Name
Instrument Installations
The following con fi gurations are described in order of complexity. The most
common setup is as a stand-alone mainframe.
Stand-alone TLA7012 portable
Stand-alone TLA7016 benchtop (requires a separate controller)
TLA7016 benchtop on a private LAN
TLA7016 benchtop on a corporate LAN
Note: You must have TLA Application software Version 5.1 or higher installed on
the controller PC.
Stand-alone Installation
(Portable Mainframe)
If you plan to use the portable mainframe as a stand-alone instrument, do the
following:
1. Set up the instrument in a convenient location relative to your target system.
2. Connect the peripheral components that you plan to use. (See page 45,
Connecting Accessories .)
3. Install the modules. (See page 41, Installing Modules .)
4. Refer to the TLA Quick Start User Manual and to the online help for operating
information.
The following fi gure shows the stand-alone setup for the portable mainframe.
10 TLA7000 Series Logic Analyzers Installation Manual