Tektronix TG700, User Manual

Page: 163 / 343

AWVG7 Analog Wideband Video Generator
Refer to AWVG7 Module Main Menu for detailed information about the main
menu items and the submenu items. (See page 3-53.)
Selecting an Output Signal
To output a signal from the AWVG7 module, you need to select a signal format
and output signal as described below.
Select the Signal Format Perform the following steps to select the signal format:
1. If the AWVG7 module menu is not displayed, press the front-panel MODULE
button until the AWVG7 module main menu appears as shown below.
2. Press the FORMAT button. The menu display changes as follows:
3. Use the left ( ◄ ) or right ( ► ) arrow button, or press the FORMAT button
repeatedly, to select one of the signal formats, and then press the ENTER
button to con fi rm the selection.
NOTE. When you change the signal format, synchronization shock occurs.
4. If you change the signal format while a test signal is being output, the
instrument starts loading all of the signal sets for the selected format and
displays the message "
Now Loading... ". When you see the message, " Done
(Press CANCEL) ", press the CANCEL button.
Select the Test Signal
All of the signal sets that are available in the module are already assigned to the
corresponding test signal buttons. When the AWVG7 module is selected and you
press any of the front-panel test signal buttons, the selected signal in the signal set
is output. (See Figure 3-26.)
TG700 TV Signal Generator Platform User Manual 3–51