Tutorial
Figure 41: Report for Inrush Current in CSV format
Taking a High Speed Signal Quality Measurement
This section discusses how to take a High Speed Signal Quality measurement,
view the results, and generate the report. To perform these tasks, the application
must be installed and enabled on a supported oscilloscope.
To take a High Speed Signal Quality measurement, follow these steps:
1.
To set the application to default values, select File > Recall Default. The
application displays the message ‘Default setup recalled successfully.’
2.
Select Measurements> High Speed and select all the Signal Quality
measurements in the Signal Quality Check area using Select All button.
3.
Select the Configure option or go to Measurements> Configure.
4.
Select the Source tab> From File>Browse and locate the file.
5.
Select the file C:\TekApplications\tdsusb2\tsvfiles\HS_sqc.tsv.
6.
Select the
command button to run the application. The application
automatically displays the Eye Diagram and the Waveform Plot.
TDSUSB2 Universal Serial Bus Measurement Package
69
Summary of Contents for TDSUSB2
