Acquisition
Starting and Stopping an Acquisition
After you have a waveform displayed and the channels that you want to acquire are selected, use the following procedure.
1.
Press the front-panel
RUN/STOP
button
to start the acquisition.
2.
Press the RUN/STOP button again to
stop the acquisition.
3.
To take a single acquisition, press the
Single
button.
Using DSP Enhanced Bandwidth
Use the DSP (digital signal processing) enhanced bandwidth for more accurate rise time measurements, to extend
the bandwidth, and
fl
atten the passband at the full sample rate (20 GS/s on the TDS6804B and 40 GS/s on TDS6000C
instruments). The enhanced bandwidth provides a matched response across enabled channels so you can perform
channel-to-channel comparison and differential measurements.
1.
Push
AUTOSET
to set the horizontal,
vertical, and trigger controls or set the
controls manually.
NOTE.
The enhanced bandwidth is 20 GS/s.
2.
Select
Vertical > Bandwidth
Enhanced...
.
TDS6000B & TDS6000C Series Quick Start User Manual
23