Application Examples
Cross-Over Voltage
Rising Edge Rate
Falling Edge Rate
3.
Select the Select All toggle button to select all the measurements
simultaneously. Click on any measurement button to deselect it.
Configuring the Measurement
Follow the steps to configure the selected measurements:
1.
From the application menu, select Measurement> Configure> Configure.
2.
Configure the following options:
Table 10. Configuring Measurements
Option Set
to
Tier
Tier6
Direction
Downstream
Test Point
Set the test point to Far End
3.
Select the Source tab.
4.
Configure the following options:
Table 11. Configure options
Option Set
to
Live/Ref Single-ended
5.
If you select Single-ended, you must select two channels for D+ and D–.
6.
Select
to acquire the data.
7.
The application automatically displays the eye diagram and waveform plot
of the signal acquired from the unit under test.
TDSUSB2 Universal Serial Bus Measurement Package
77
Summary of Contents for TDS5032
