Tektronix TDS1001C-EDU, Service Manual

Page: 69 / 114

Maintenance
Flip Feet You will need a pair of needle-nose pliers to remove the fl ip feet.
Refer to the exploded view diagram. (See page 96.)
Removal.
1. Place the oscilloscope face down on a soft surface such as an anti-static mat.
2. Grip the fl ip foot with the pliers as close to the notches as possible and
squeeze gently on the foot.
3. Twist slightly to swing one hinge free of the slot.
4. Remove the fl ip foot from the case.
Installation.
1. Place the oscilloscope face down on a soft surface such as an anti-static mat.
2. Hold the fl ip foot with the smooth side facing down.
3. Gently squeeze the foot so that the hinge on one side fi ts into the slot, and
twist slightly to snap into the slot on the other side.
Front-Panel Knobs
Refer to the exploded view diagram for the 2-channel models or the 4-channel
models. (See page 89.) (See page 92.)
NOTE.
Wrap the plier jaws with tape (such as electrical tape) to avoid scratching
the knob.
Removal.
Firmly grasp the knob (with pliers if necessary) and pull it away from
the front panel.
Installation. Align the keyed knob with the shaft and press the knob onto the shaft.
Power Button
Refer to the exploded view diagram for either the 2-channel or the 4-channel
models. (See page 89.) (See page 94.)
NOTE.
Wrap the plier jaws with tape (such as electrical tape) to avoid scratching
the button.
Removal.
Firmly grasp the button with pliers and pull it straight out of the cabinet.
Installation. Press the button onto the power button shaft until it snaps into place.
TDS2000C and TDS1000C-EDU Series Oscilloscope Service Manual 57