Tektronix TDS1001C-EDU, Service Manual

Page: 13 / 114

Speci fi cations
These speci fi cations apply to all TDS2000C and TDS1000C-EDU series
oscilloscopes. To verify that an oscilloscope meets speci fi cations, it must fi rst
meet the following conditions:
The oscilloscope must have been operating continuously for twenty minutes
within the speci
fi ed operating temperature.
You must perform the Do Self Cal operation, accessible through the Utility
menu, if the operating temperature has changed by more than 5 °C (9 °F)
since the last time the Do Self Cal operation was performed.
Speci fi cations are provided in the following tables. All speci fi cations are
guaranteed unless noted "typical." Speci fi cations that are marked with the symbol
are checked in the Performance Veri fi cation section. (See page 27, Performance
Veri fi cation .)
Signal Acquisition System Characteristics
NOTE.
All amplitude-related or modi fi ed speci fi cations require 1X probe
attenuation factors unless otherwise speci fi ed. This is due to the way the displayed
sensitivity works. This does not affect actual methods of attachment. It only alters
the relationship between displayed scale factors and the speci
fi cations.
Table 1: Signal acquisition system characteristics
Characteristic Description
TDS1001C-EDU
TDS1002C-EDU
TDS1012C-EDU
TDS2001C
TDS2002C
TDS2012C
TDS2022C Two nominally identical channels, sampled
simultaneously. Number of Input
Channels
TDS2004C
TDS2014C
TDS2024C Four nominally identical channels, sampled
simultaneously.
Input Coupling DC, AC, or GND
Input Impedance, DC
Coupled 1 M Ω ±2% in parallel with 20 pF ±3 pF
TDS2000C and TDS1000C-EDU Series Oscilloscope Service Manual 1