Maintenance
Maintenance
This section contains maintenance and support information for your probe.
Host instrument
fi
rmware
Some instruments may require a
fi
rmware upgrade to support full functionality of the TDP0500 and TDP1000 probes. Instruments
with lower version
fi
rmware may not display all probe controls and indicators on screen, and in some cases may require you to
power-cycle the instrument to restore normal instrument operation. The following table lists the required versions of instrument
fi
rmware.
Instrument
Firmware Version
DPO7000 series
V2.0.0 or higher
To check the
fi
rmware version on Windows-based instruments, from the menu bar, click Help/About TekScope. On
Linux-based instruments, press the Utilities button on the front panel. If you need to upgrade your instrument
fi
rmware, go to
www.tektronix.com/software to download the latest
fi
rmware.
Error condition
If one of the Range LEDs does not remain lit after you connect the probe, an internal probe diagnostic fault exists. Disconnect and
reconnect the probe to restart the power-on diagnostic sequence. If the symptoms continue, the probe is defective, and must
be returned to Tektronix for repair.
TDP0500 & TDP1000 Quick Start User Manual
43
