Tektronix RSA6100A Series, Help Manual

Page: 247 / 415

GP Digital Modulation > Eye Diagram Eye Diagram Settings
Eye Diagram Settings
Menu Bar: Setup > Settings
Front Panel / Application Toolbar: Settings .
The settings for the Eye Diagram display are shown in the following table.
NOTE.
You might be able to save time con fi guring the Eye Diagram display by pressing the Standard
Settings button from the Settings control panel. This allows you to select a preset optimized for a standard
from the Select Standard dialog box. See
Standard Settings Button. (see page 256)
Settings tab Description
Modulation Params (see
page 256) Speci fi es the type of modulation used for the input signal and other parameters.
Freq & BW (see page 261) Speci fi es settings for frequency error, measurement BW and Frequency Deviation. Each
of these settings is set internally when set to Auto. Alternatively, you can specify values
appropriate for speci
fi c measurement needs.
Advanced Params (see
page 262) Speci fi es additional parameters.
Find (see page 265) Used to set parameters for fi nding a burst within the data record and for entering a
Synch word.
Analysis Time (see page 265) Contains parameters that de fi ne the portion of the acquisition record that is used for
analysis. Also allows you to specify the Units (Seconds or Symbols) for the GP Digital
Modulation displays.
Trace (see page 267)
Allows you to set the trace display characteristics.
Scale (see page 268) Speci fi es the horizontal and vertical scale settings.
Prefs (see page 269) Enables you to set characteristics of the measurement display.
xxx
RSA6100A Series Real-Time Spectrum Analyzers Help
235