Tektronix PWS4205, Programmer'S Manual

Page: 71 / 90

Status and Events
Command Errors The following table shows the command error messages generated by improper
syntax. Check that the command is properly formed and that it follows the rules
in the section on command Syntax.
Table 3-6: Command error messages (CME bit 5)
Code Message
101 Design error: Too many numeric suf fi ces in Command Spec
110
No Input Command to parse
114
Numeric suf fi x is invalid value
116
Invalid value in numeric or channel list, e.g. out of range
117 Invalid number of dimensions in a channel list
120 Parameter of type Numeric Value over fl owed its storage
130 Wrong units for parameter
140 Wrong type of parameter(s)
150 Wrong number of parameters
160 Unmatched quotation mark in parameters (single/double)
165 Unmatched bracket
170 Command keywords were not recognized
180 No entry in list to retrieve
190 Too many dimensions in entry to be returned in parameters
191 Too many char
Execution Errors
The following table lists the execution errors that are detected during execution of
a command.
Table 3-7: Execution error messages (EXE bit 4)
Code Message
–200 Execution error
–221 Settings con fl ict
–222 Data out of range
–223 Too much data
–224 Illegal parameter value
–225 Out of memory
–270 Macro error
–272 Macro execution error
–273 Illegal macro label
–276 Macro recursion error
–277 Macro rede fi nition not allowed
PWS4205, PWS4305, PWS4323, PWS4602, and PWS4721 Power Supply Programmer Manual 3-9