Pulse Pro
fi
ling Application
Pulse Pro
fi
ling Application
NOTE.
This application is only available for PSM5000 series instruments.
For basic CW and pulse power measurements, use the Power Meter application.
To perform detailed measurements on repetitive, pulsed RF and microwave
signals with PSM5000 series instruments, use the Pulse Pro
fi
ling application.
This application displays a trace of the pulse envelope and allows you to take
measurements at any point on the trace.
CAUTION.
Do not 23 dBm, 200 mW, or 3.15 VRMS. Ensure that the RF
input connector on the sensor and the mating connector are clean and undamaged.
NOTE.
Using more than one type of application at a time can result in errors. It is
recommended that you use only one type of application at a time.
Menu Features
The main elements of the Pulse Pro
fi
ling application interface are shown here.
Figure 3: Pulse Pro
fi
ling application interface
RF and Microwave Power Sensors/Meters
31
Summary of Contents for PSM3000 Series
