Tektronix PSM3000 Series, User Manual, Page: 40 / 76

Power Meter Application
Table 2: Power Meter default values (cont.)
Parameter Default value
Response 0 dB, disabled
Duty Cycle 10%, disabled
Minimum Loss Pad (75 ohm) Not selected. The Default Setup button will not
change the input impedance if this value is selected
(enabled). Application launch sets the input to 50
Ω .
Trigger Mode Internal Continuous
Trigger Out
Disabled
Recall Factory Setup Select this menu item from the Utility drop down menu to reset all measurement
parameters and user preferences, such as display color and window size, to default
settings.
Sensor ID Click this button to identify an instrument. The LED on the identi fi ed instrument
will blink four times. This is particularly useful when multiple instruments are
connected.
You can also fi nd this item in the Utility drop down menu.
Set Address This item is located in the Utility drop down menu. Use it to set an instrument
address. This is particularly useful when multiple instruments are connected.
NOTE.
Changing the address requires re-initialization of the USB connection.
After changing the instrument address, the application will close and must be
reopened.
Set Sensor Name
This item is located in the Utility drop down menu. Use it to set an instrument
name for the current session only. This is particularly useful when multiple
instruments are connected.
Error Messages
Various error windows will appear if there is a hardware or software problem or
con
fl ict. Follow the message instructions to correct the problem.
26 RF and Microwave Power Sensors/Meters