Tektronix P6249, Instruction Manual

Page: 46 / 76

Performance Verification
34
P6249 4 GHz 5X Active Probe Instruction Manual
Table 8: Equipment required for performance verification (Cont.)
Item Description Recommended Example
Performance
Requirement
BNC-to-BNC coaxial cable
50
Ω
coaxial cable
012-1342-00
Coaxial cable Male-to-Male SMA, 20 in 174-1427-00
Precision coaxial cable Male-to-Male SMA, 1 ns
delay 015-0562-00
Adapter SMA Female-to-Female 015-1012-00
Adapters (2) SMA Female-to-BNC Male 015-0572-00
Adapter BNC Female-to-Dual
Banana 103-0090-00
Adapter Y-lead adapter 196-3457-00
Adapters (2) Klip Chip adapter 206-0364-00
Equipment Setup
Use this procedure to set up the equipment to test the probe.
1.
Connect the probe to the oscilloscope.
2.
Connect a Y-lead adapter with KlipChip adapters attached to the
P6249.
3.
Turn on the oscilloscope and enable the channel.
4.
Allow 30 minutes for the equipment to warm up.
NOTE
. If your oscilloscope has a probe calibration routine, run it
before making any of the following checks. However, certain
firmware versions of TDS series oscilloscopes will return a Probe Cal
Failed message. If this occurs, see
Probe Calibration Errors on
page 14 for more information.