Tektronix MSO54, Programmer'S Manual

Page: 880 / 1026

Commands listed in alphabetical order
Syntax
TRIGger:{A|B}:SETHold:HOLDTime <NR3>
TRIGger:{A|B}:SETHold:HOLDTime?
Arguments
<NR3>
is a fl oating point number that speci fi es the hold time setting, in seconds.
Positive values for hold time occur after the clock edge. Negative values occur
before the clock edge.
Examples
TRIGger:A:SETHold:HOLDTime 3.0E-3
sets the hold time for the setup and
hold trigger to 3 ms.
TRIGger:A:SETHold:HOLDTime?
might return
:TRIGGER:A:SETHOLD:HOLDTIME 2.0000E-09
indicating that the current
hold time for the setup and hold trigger is 2 ns.
TRIGger:{A|B}:SETHold:SETTime
This command speci fi es the setup time for setup and hold violation triggering.
This command is equivalent to selecting Setup/Hold Setup from the Trig menu
and then setting the desired Setup Time.
Group Trigger
Syntax
TRIGger:{A|B}:SETHold:SETTime <NR3>
TRIGger:{A|B}:SETHold:SETTime?
Arguments
<NR3>
is a fl oating point number that speci fi es the setup time for setup and hold
violation triggering.
Examples
TRIGger:A:SETHold:SETTime 3.0E-6
speci fi es that the current setup time
for setup and hold trigger is 3 µs.
TRIGger:A:SETHold:SETTime?
might return
:TRIGGER:A:LOGIC:SETHOLD:SETTIME 2.0000E-09
indicating that the
current setup time for setup and hold trigger is 2 ns.
TRIGger:{A|B}:SETHOLDLogicval:{CH<x>|CH<x>_D<x>}
This command sets or queries whether the speci fi ed channel is included
(INCLude) or not included (DONTInclude) in the Setup & Hold trigger input
con
fi guration. The channel number is speci fi ed by <x>.
2-864 MSO54, MSO56, MSO58, MSO58LP Programmer