Tektronix MSO54, Programmer'S Manual

Page: 836 / 1026

Commands listed in alphabetical order
Examples
TRIGGER:A:BUS:B1:MIL1553B:DATA:VALUE "XXXXXXXXXXXX1000"
sets
the value to XXXXXXXXXXXX1000.
TRIGGER:A:BUS:B1:MIL1553B:DATA:VALUE?
might return
"XXXXXXXXXXXXXXXX", indicating that the value is
XXXXXXXXXXXXXXXX.
TRIGger:{A|B}:BUS:B<x>:MIL1553B:ERRTYPe
This command sets or queries the type of error condition for a MIL-STD-1553
bus to trigger on. The bus number is speci
fi ed by x. The trigger condition must
be set to ERRor.
Conditions Requires the SR-AERO Triggering and Analysis application.
Group Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:MIL1553B:ERRTYPe
{PARity|SYNC|DATA}
TRIGger:{A|B}:BUS:B<x>:MIL1553B:ERRTYPe?
Arguments
PARity
speci fi es triggering on an incorrectly calculated parity bit in any word.
SYNC
speci fi es triggering on any sync pulse that does not transition in the middle
of the pulse as required.
DATA
speci fi es triggering on any non-contiguous data words.
Examples
TRIGGER:A:BUS:B1:MIL1553B:ERRTYPE DATA
speci fi es triggering on
non-contiguous data words.
TRIGGER:A:BUS:B1:MIL1553B:ERRTYPE?
might return PARITY, indicating
that the bus is triggering on parity errors in any word.
TRIGger:{A|B}:BUS:B<x>:MIL1553B:STATus:ADDRess:HIVALue
This command sets or queries the high value when triggering on status word
addresses for a MIL-STD-1553 bus. The bus number is speci
fi ed by x. The
trigger condition must be set to STATus and the address quali fi er must be INrange
or OUTrange.
Conditions Requires the SR-AERO Triggering and Analysis application.
2-820 MSO54, MSO56, MSO58, MSO58LP Programmer