Tektronix MSO54, Programmer'S Manual

Page: 665 / 1026

Commands listed in alphabetical order
Examples
SEARCH:SEARCH1:TRIGger:A:BUS:CAN:IDentifier:VALue "1010"
sets
the identi fi er value to 1010.
SEARCH:SEARCH1:TRIGger:A:BUS:CAN:IDentifier:VALue?
might return
:SEARCH:SEARCH1:TRIGGER:A:BUS:CAN:IDENTIFIER:VALUE "101011"
,
indicating the identi fi er value is 101011.
SEARCH:SEARCH<x>:TRIGger:A:BUS:ETHERnet:CONDition
This command speci fi es a fi eld or condition for an Ethernet bus to search on.
The search number is speci fi ed by <x>.
Conditions
Requires the SR-ENET Triggering and Analysis application.
Group Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:ETHERnet:CONDition
{SFD|MACADDRess|MACLENgth|IPHeader|TCPHeader|DATa|EOP|
IDLe|FCSError|QTAG}
SEARCH:SEARCH<x>:TRIGger:A:BUS:ETHERnet:CONDition?
Related Commands Most of the other
TRIGger:A:BUS:B<x>:ETHERnet
commands are impacted
by the setting of this command.
Arguments
SFD
– Start of frame delimiter.
MACADDRess
– MAC addresses fi eld.
MACLENgth
– MAC length/type fi eld.
IPHeader
– IP header fi eld. .
TCPHeader
– TCP header fi eld.
DATa
– TCP/IPv4 or MAC protocol client data fi eld.
EOP
– End of Packet fi eld.
IDLe
– Idle fi eld.
FCSError
– Frame Check Sequence Error (CRC) fi eld.
QTAG
– IEEE 802.1Q (VLAN) control information fi eld.
Examples
SEARCH:SEARCH1:TRIGGER:A:BUS:ETHERNET:CONDITION MACADDRESS
speci fi es
MACADDRess
as the fi eld within an Ethernet frame to search on.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-649