Tektronix MSO54, Programmer'S Manual

Page: 589 / 1026

Commands listed in alphabetical order
For Cycle Base measurement, the parameters is “LOW”.
For Cycle Max measurement, the parameters is “MAX”.
For Cycle Min measurement, the parameters is “MIN”.
Examples
POWer:POWer1:RESUlts:CURRentacq:MEAN? "TruePwr"
might return
38.7856097255943E–9, indicating the mean value of true power for the current
acquisition.
POWer:POWer<x>:RESUlts:CURRentacq:MINimum? (Query Only)
This command queries the minimum value of the current acquisition for the
measurement parameter in the speci
fi ed power measurement badge. The power
measurement badge is speci fi ed by x.
Conditions
Requires option 5-PWR, SUP5-PWR, or 5-PS2.
Group Power
Syntax
POWer:POWer<x>:RESUlts:CURRentacq:MINimum?
<QString>
Arguments
<QString>
= parameters of the measurements. The details of the parameters for
the Power measurements are listed below:
For Power Quality measurement, the parameters are "TRUEPWR" | "APPPWR"
| "REPWR" | "PWRFACTOR" | "PHASE" | "PWRFREQ" | "ICFACTOR" |
"VCFACTOR" | "IRMS" | "VRMS".
For Switching Loss measurement, the parameters are "TONENRG" | "TONLOSS"
| "TOFFENRG" | "TOFFLOSS" | "CONDENRG" | "CONDLOSS" | "TTLLOSS" |
"TTLENRG".
For dV by dt measurement, the parameter is “DVBYDT”.
For dI by dt measurement, the parameter is “DIBYDT”.
For SOA measurement, the parameter is “SOAHITSCNT”.
For Line Ripple measurement, the parameters are “LRIPRMS” | “LRIPPKPK”.
For Switching Ripple measurement, the parameters are “SWRIPRMS” |
“SWRIPPKPK”.
For Cycle Period measurement, the parameters is “PRIOD”.
For Cycle Frequency measurement, the parameters is “FREQ”.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-573