Tektronix MSO54, Programmer'S Manual

Page: 457 / 1026

Commands listed in alphabetical order
MEASUrement:MEAS1:COMMONMode:SOURCEs?
might return
:MEASUREMENT:MEAS1:COMMONMODE:SOURCES DOUBLE
indicating sources
are set to double.
MEASUrement:MEAS<x>:CYCLemode
This command sets or queries the cycle mode for the measurement. Measurements
are speci
fi ed by x.
Group Measurement
Syntax
MEASUrement:MEAS<x>:CYCLemode {RECORD|CYCLE}
MEASUrement:MEAS<x>:CYCLemode?
Arguments
RECORD
speci fi es that the measurement is taken over the whole record.
CYCLE
speci fi es that measurements are taken on each cycle of the source.
Examples
MEASUrement:MEAS1:CYCLemode CYCLE
sets the measurement to be taken
over each cycle of the source.
MEASUrement:MEAS1:CYCLemode?
might return
:MEASUREMENT:MEAS1:CYCLEMODE RECORD
indicating the measurement is
taken over the whole record.
MEASUrement:MEAS<x>:DELay:EDGE<x>
This command sets or queries the 'to edge' type when EDGE<x> is EDGE1 and
the 'from edge' type when EDGE<x> is EDG2, for the measurement when the
measurement type is DELAY. Measurements are speci
fi ed by x.
Group Measurement
Syntax
MEASUrement:MEAS<x>:DELay:EDGE<x>
{FALL|RISe|BOTH|SAMEas|OPPositeas}
MEASUrement:MEAS<x>:DELay:EDGE<x>?
Related Commands MEASUrement:MEAS<x>:TOEdge
MSO54, MSO56, MSO58, MSO58LP Programmer 2-441