Tektronix MSO54, Programmer'S Manual

Page: 167 / 1026

Commands listed in alphabetical order
Syntax
BUS:B<x>:LABel:XPOS <NR3>
BUS:B<x>:LABel:XPOS?
Arguments
<NR3>
is the x-position, in pixels relative to the left edge of the screen,, of the
speci fi ed bus label.
Examples
BUS:B1:LABel:XPOS 90
set the x position to 90.
BUS:B1:LABel:XPOS?
might return
:BUS:B1:LABEL:XPOS 45.0000
indicating the x position is 45.0 pixels to the right of the left edge of the display.
BUS:B<x>:LABel:YPOS
This command sets or queries the y-position of the speci fi ed bus label. The bus
is speci fi ed by x.
Group Bus
Syntax
BUS:B<x>:LABel:YPOS <NR3>
BUS:B<x>:LABel:YPOS?
Arguments
<NR3>
is the y-position, in pixels relative to the baseline of the waveform, of
the speci fi ed bus label.
Examples
BUS:B1:LABel:YPOS 1.0e1
set the y position to 10.0.
BUS:B1:LABel:YPOS?
might return
:BUS:B1:LABEL:YPOS 0.0E+0
indicating the y position is 0.0 pixels from the baseline of the waveform.
BUS:B<x>:LIN:BITRate
This command sets or queries the LIN bus bit rate. The bus number is speci fi ed by
x. If you select Custom, use BUS:B<x>:LIN:BITRate:CUSTom to set the bit rate.
Conditions
Requires option SR-AUTO.
Group Bus
Syntax
BUS:B<x>:LIN:BITRate
{RATE10K|RATE1K|RATE19K|RATE2K|RATE4K|RATE9K|CUSTom}
MSO54, MSO56, MSO58, MSO58LP Programmer 2-151