Acquire the Signal
2.
Push Trigger
Menu
and enter trigger
parameters. (See page 83,
You can display bus information without
triggering on the bus signal.
Setting Up Bus Parameters
NOTE.
For most bus sources, you may use any combination of channels 1 through 4, and D15 through D0. With some
buses, you may also use Ref 1 through 4 and Math as sources for protocol decode.
To trigger on serial or parallel bus conditions, refer to Triggering on Buses. (See page 86,
To set up bus parameters:
1.
Push
B1
,
B2
,
B3
, or
B4
to bring up the
lower-bezel bus menu.
2.
Push
Bus
. Turn multipurpose knob
a
to
scroll through the list of bus types and select
the desired bus: Parallel, I
2
C, SPI, RS-232,
CAN, LIN, FlexRay, Audio, USB, Ethernet, or
MIL-STD-1553.
Bus B1
Parallel
De
fi
ne
Inputs
Thresholds
B1 Label
Parallel
Bus
Display
Event
Table
The actual menu items shown will depend on
your model oscilloscope and the application
modules installed.
3.
Push
De
fi
ne Inputs
. The choices depend
on the selected bus.
MDO4000 Series Oscilloscopes User Manual
61
Summary of Contents for MDO4054-3
