Tektronix MDO4054-3, User Manual, Page: 79 / 222

Acquire the Signal
Setting Up a Serial or Parallel Bus
Your oscilloscope can decode and trigger on signal events or conditions that occur on:
Bus type With this hardware
Audio (I
2
S, Left Justi fi ed (LJ), Right
Justi fi ed (RJ), and TDM)
DPO4AUDIO application module
CAN and LIN DPO4AUTO or DPO4AUTOMAX application module
Ethernet DPO4ENET application module
FlexRay DPO4AUTOMAX application module
I
2
C and SPI DPO4EMBD application module
MIL-STD-1553 DPO4AERO application module
Parallel MDO4000 Series oscilloscope
RS-232, RS-422, RS-485, and
UART DPO4COMP application module
USB 2.0 DPO4USB application module
(See page 15, Application Module Free Trial .)
Using Buses in Two Steps
To quickly use serial bus triggering:
1. Push B1 , B2 , B3 , or B4 and enter
parameters of the bus on which to trigger.
You can separately assign a different bus to
each of the
B1 , B2 , B3 , and B4 buttons.
60 MDO4000 Series Oscilloscopes User Manual