Trigger setup
This section contains concepts and procedures for setting up the oscilloscope to
trigger on your signal.
Choosing a trigger type
To select a trigger:
1.
Push Trigger
Menu
.
2.
Push
Type
to bring up the
Trigger Type
side menu.
NOTE.
The bus trigger in the MDO4000C Series works on parallel buses even
without an application module. Using the bus trigger on other buses requires use
of a DPO4AERO, DPO4AUDIO, DPO4AUTO, DPO4AUTOMAX, DPO4COMP,
DPO4EMBD, DPO4ENET, or DPO4USB application module.
3.
Turn multipurpose knob
a
to select the desired trigger type.
4.
Complete the trigger setup using the lower menu controls displayed for the
trigger type. The controls to set up the trigger vary depending on the trigger
type.
Type
Edge
Source
1
Coupling
DC
Slope
Level
100 mV
Mode
Auto
& Holdoff
2
4
4
4
4
MDO4000C Series Oscilloscope User Manual
53
Preliminary
Summary of Contents for MDO4000C Series
Page 2: ...P r e l i m i n a r y...
Page 20: ...Compliance Information xvi MDO4000C Series Oscilloscope User Manual P r e l i m i n a r y...
Page 74: ...Acquire the signal 52 MDO4000C Series Oscilloscope User Manual P r e l i m i n a r y...
Page 140: ...Save and recall information 118 MDO4000C Series Oscilloscope User Manual P r e l i m i n a r y...
