Application module free trial
A 30-day free trial is available for all application module licenses not installed in
your oscilloscope. The trial period begins when you power on the oscilloscope
for the first time.
After 30 days, you must purchase the module if you want to continue using the
application. To see the date when your free trial period expires, push
Utility
on
the front panel, push
Utility Page
on the lower menu, use multipurpose knob
a
to
select
Config
, push
About
on the lower menu, and then push Application
Modules on the side menu to see the expiration date.
Installing an application module
CAUTION.
To avoid damage to the oscilloscope or application module, observe
ESD (electrostatic discharge) precautions. See
on page 11.
Turn off the oscilloscope power while removing or adding an application module.
Optional application module packages extend the capability of your oscilloscope.
You can physically install up to four application modules at one time.
Application modules go into the two slots with windows in the upper right corner
of the front panel. Two additional slots are directly behind the two that you can
see. To use these slots, install the module with the label facing away from you.
Some of the modules have licenses which allow you to transfer the license
between your application modules and the oscilloscope. You can keep each
license in the module, which will allow you to move the module from one
instrument to another. Alternatively, you can move the license from the module
to the oscilloscope. This approach will allow you to store the module separately
from the oscilloscope for safe keeping. This approach will also allow you to use
more than four applications on your oscilloscope simultaneously. To transfer a
license from a module to your oscilloscope or from your oscilloscope to a
module:
1.
Turn off the power to the oscilloscope. Insert the application modules into the
oscilloscope. Turn on the power.
2.
Push
Utility
on the front panel. If needed, push
Utility Page
on the lower
menu and turn multipurpose knob a to select
Config
. Push
Manage Modules
and Options
on the lower menu, and then push
License Type
on the side
menu until “Modules” is selected. The licenses contained in the oscilloscope
will be listed in the side menu. Push the button next to the appropriate license
to transfer. You may transfer up to four licenses at one time.
3.
After you turn off the power to the oscilloscope, you can remove the physical
application module from the oscilloscope.
Installation
18
MDO4000C Series Oscilloscope User Manual
Preliminary
Summary of Contents for MDO4000C Series
Page 2: ...P r e l i m i n a r y...
Page 20: ...Compliance Information xvi MDO4000C Series Oscilloscope User Manual P r e l i m i n a r y...
Page 74: ...Acquire the signal 52 MDO4000C Series Oscilloscope User Manual P r e l i m i n a r y...
Page 140: ...Save and recall information 118 MDO4000C Series Oscilloscope User Manual P r e l i m i n a r y...
