In this section:
Introduction ............................................................................... 5-1
Equipment needed ................................................................... 5-1
Connect the instrument to the Model 8010 ............................... 5-2
Install the device and make connections .................................. 5-3
Set up communication .............................................................. 5-3
Example program code ............................................................ 5-4
Example program usage .......................................................... 5-9
Introduction
In this example, you will generate high speed current and voltage waveforms for a device with axial
leads that is installed on the high current side of the Model 8010. This example illustrates how to
connect to the device. It also demonstrates how to program the Model 2651 to output a pulse and
generate high-speed current and voltage waveforms.
Equipment needed
•
One Model 8010 High Power Test Fixture with the Model 8010-DTB or Model 8010-DTB-220
board installed on the high current side of the test fixture (see
2-3) for more information)
•
One Model 2651 High Power System SourceMeter instrument
•
One device with axial leads, such as a resistor or diode
•
Cables to connect the Model 2651 to the Model 8010: One Model 2651-KIT-1, one Model
CA-557-1
•
Cables to connect instruments to the device in the Model 8010: One Model CA-560-0, one Model
CA-562-0, one Model CA-562-2, and one Model 560-2 cable
•
One GPIB cable or Ethernet cable
Section 5
Axial-lead device high current test
