Tektronix KEITHLEY 707B, Reference Manual

Page: 436 / 534

Models 707B and 708B Switching Matrix Reference Manual Section 7: TSP command reference
707B-901-01 Rev. B / January 2015 7-205
Example
digio.trigger[3].mode = digio.TRIG_FALLING
digio.trigger[5].mode = digio.TRIG_FALLING
trigger.blender[1].orenable = true
trigger.blender[1].stimulus[1] = digio.trigger[3].EVENT_ID
trigger.blender[1].stimulus[2] = digio.trigger[5].EVENT_ID
Generate a trigger blender 1
event when a digital I/O
trigger happens on line 3 or
5.
Also see
trigger.blender[N].reset() (on page 7-203)
trigger.blender[N].wait()
This function waits for a blender trigger event to occur.
Type TSP-Link accessible
Affected by Where saved Default value
Function Yes
Usage
triggered = trigger.blender[ N ].wait( timeout )
triggered Trigger detection indication for blender
N
The trigger blender (1 or 2) on which to wait
timeout Maximum amount of time in seconds to wait for the trigger blender event
Details
This function waits for an event blender trigger event. If one or more trigger events were detected
since the last time
trigger.blender[ N ].wait()
or
trigger.blender[ N ].clear()
was
called, this function returns immediately.
After detecting a trigger with this function, the event detector automatically resets and rearms. This is
true regardless of the number of events detected.
Example
digio.trigger[3].mode = digio.TRIG_FALLING
digio.trigger[5].mode = digio.TRIG_FALLING
trigger.blender[1].orenable = true
trigger.blender[1].stimulus[1] = digio.trigger[3].EVENT_ID
trigger.blender[1].stimulus[2] = digio.trigger[5].EVENT_ID
print(trigger.blender[1].wait(3))
Generate a trigger blender 1
event when a digital I/O
trigger happens either on
line 3 or 5.
Wait three seconds while
checking if trigger blender 1
event has occurred.
If the blender trigger event
has happened, then
true
is
output. If the trigger event
has not happened, then
false
is output after the
timeout expires.
Also see
trigger.blender[N].clear() (on page 7-201)