Models 707B and 708B Switching Matrix Reference Manual
Section 2: General operation
707B-901-01 Rev. B / January 2015
2-19
Set beeper and key clicks
You can turn the instrument beeper and key click sounds on or off.
Disabling the beeper also disables the keyclicks. To enable keyclicks, you must also enable the
beeper.
To change the beeper or key click sounds from the front panel:
1. Press
MENU
.
2. Use the navigation wheel to select BEEPER.
3. Select KEYCLICK or BEEP.
4. Select ENABLE or DISABLE.
5. Press
ENTER
or press the navigation wheel to save the change.
6. Press
EXIT (LOCAL)
to return to the Main Menu.
Menu options
The menus that can be accessed from the front panel of the instrument allow you to set up and run
the instrument.
LOAD TEST menu options
Allows you to run scripts and code from the front panel that you created through the communication
interface, or configuration scripts created by pressing the front-panel MENU key, then selecting
SCRIPT > CREATE-CONFIG.
To open this menu, press
LOAD
.
The User option loads code that was added to Load Test with the
(on page 7-
70) command.
The Scripts option loads named scripts that were added to the run-time environment.
After selecting code or script from the User or Scripts option, you can press
RUN
to execute the
selected code or script.
Channel Attribute Menu options
The options in the Channel Attribute Menu allow you to configure channels from the front panel.
To open the Channel Attribute Menu, go to channel view. Select the channel for which you want to
set attributes, then press
CONFIG
, then press
CHAN
.
