Model 4200A-SCS Parameter Analyzer User's Manual
Section 4: Use the RPM to switch the SMU, CVU, and PMU
4200A-900-01 Rev. C / January 2019
4-5
Connect the 4200A-SCS to the DUT
The next figure shows the 4200A-SCS rear panel connections to the input terminals of two
4225-RPMs and from the outputs of the 4225-RPMs to the diode.
Figure 31: Rear panel connections to the inputs of the 4225-RPM units and from the units to
the device
Set up the measurements in Clarius
This section describes how to set up the 4200A-SCS to make I-V, C-V, and pulsed I-V measurements
on a diode. You will create a new project and add a test to the project tree for each measurement
type.
For this example, you will use the Clarius application to:
Create a new project
Add a device
Search for and select existing tests in the Test Library
Configure the tests
Run the tests
View and analyze the test results
