Tektronix IsoVu TIVM Series, User Manual

Page: 13 / 82

Important safety information
on the instrument and your application. Refer to the Speci fi cations section of the
manual for more information.
WARNING.
To prevent electrical shock, do not exceed the maximum measurement
or maximum voltage category.
Connect and disconnect properly.
CAUTION.
To avoid damage to the equipment, de-energize the test circuit before
connecting or disconnecting the sensor tip cable.
Service safety summary
The Service safety summary section contains additional information required to
safely perform service on the product. Only quali fi ed personnel should perform
service procedures. Read this Service safety summary and the General safety
summary before performing any service procedures.
To avoid electric shock.
Do not touch exposed connections.
Do not service alone. Do not perform internal service or adjustments of this
product unless another person capable of rendering fi rst aid and resuscitation is
present.
Disconnect power.
To avoid electric shock, switch off the product power and
disconnect the power cord from the mains power before removing any covers or
panels, or opening the case for servicing.
Use care when servicing with power on.
Dangerous voltages or currents may exist
in this product. Disconnect power, remove battery (if applicable), and disconnect
test leads before removing protective panels, soldering, or replacing components.
Verify safety after repair.
Always recheck ground continuity and mains dielectric
strength after performing a repair.
TIVM Series Measurement System User Manual vii