Tektronix H600 RFHawk, Service Manual

Page: 60 / 109

Removal and Replacement Procedures
Removal and Replacement Procedures
This subsection contains procedures for the removal and replacement of all
replaceable mechanical and electrical modules.
NOTE.
The instrument does not require calibration after removal and replacement
of the indicated parts.
Preparation
WARNING. Before doing this or any other procedure in this manual, read the
Safety Summary found at the beginning of this manual. Also, to prevent possible
damage to the instrument components, read Preventing ESD in this section. (See
page 4-3.)
This subsection contains the following items:
This preparatory information that you need to properly do the procedures
that follow.
List of tools required to remove and disassemble all modules.
Procedures for removal and reinstallation of the electrical and mechanical
modules.
CAUTION.
Disconnect the power adapter and remove all batteries from the
instrument before disassembling the instrument.
Equipment Required
Table 4-1: Tools required
Item
no.
Name Description General Tool number
1. Screwdriver handle Accepts Torx-driver and
Pozi bits 620-440
2. T-9 Torx tip Used for removing
instrument screws 640-234
3. T-10 Torx tip Used for removing
instrument screws 640-235
4. T-15 Torx tip
Used for removing
instrument screws
640-247
5.
P0 Pozi tip Used for removing
instrument screws 640-234
4–2 H600 & SA2600 Service Manual