2-43
Installation
Optional Frame Module Installation
These instructions are provided for installing the Model 4000 Signal Frame options
if they have been ordered after your original switcher installation. If you ordered
any options with your original switcher, the options have already been installed
and you may skip these steps.
There are two types of optional circuit boards used in the switcher. A full sized
circuit board that slides into a frame bay is called a “module.” A second circuit
board type is a smaller “mezzanine” board which uses pin connectors and
attaching screws to mount on a module.
Empty module cells in the C and D Bays have blank metal strips screwed in place
to maintain proper air flow inside the switcher and to preserve the EMI status.
These must be removed before the options purchased after your initial installation
can be installed.
Many options require operating and configuration parameters to be set in the main
menu panel. Refer to the Model 4000 User’s Guide (TP0790) and Operation
Reference (TP0764) Manuals for detailed information.
CAUTION
Special EMI fingers are installed on each module connector and blank strip in bays
C and D. Use extreme care when removing or installing the modules and blank
strips so that the EMI fingers do not break off.
Input Modules
Primary inputs to the Model 4000 switchers are chosen from a list of input options.
The inputs can be analog component and/or component serial digital. A total of
64 inputs may be installed in any combination of video and key. Up to 8
Component Analog Input Module options can be installed providing 32 analog
inputs (16 CAV and 16 analog key inputs). The system can accept up to 8 Serial
Input Module options providing eight serial inputs per module.
Up to three optional Chroma Key Input Modules can be installed. Each Chroma
Key Input Module provides two full bandwidth manually timed external analog
component inputs which can be routed to any M/E with the optional chroma
keyer installed.
Serial Digital Input Module Options—
Each optional Serial Digital Input Module can
accommodate 8 serial digital component inputs. Up to 8 modules can be installed
in the Model 4000 for a total of 64 serial digital video/key inputs.
The Serial Input Modules (064820) reside in the upper rear C Bay of the Signal
Processor Frame as illustrated in
Summary of Contents for Grass Valley 4000
