Tektronix Grass Valley 4000, Installation And Service, Page: 44 / 286

2-10
Section 2 — Installation
Model 4000-3 Control Panel Console Dimensions
These instructions allow you to install your Control Panel in a full flush-mount
installation. For a semi flush-mount installation, simply cut the console to the
dimensions indicated in
Figure 2-7 , set both Control Panel tubs in the console, and
complete Steps 1, 4, 9, and 10 on both tubs. For a full flush mount installation, it is
recommended that the Control Panel be on site before cutting the holes and
fabricating the routed flanges.
1. Using the dimensions shown in Figure 2-7 , make a cutout in the console to
accommodate the Model 4000-3 upper Control Panel unit.
2. Route a 1/2” (12 mm) by 3/8” (9 mm) lip around the right, left, and top edge
of the cutout. For clarification the routed edges of the cutout are illustrated in
Figure 2-8 .
Note that in all four corners, clearance must be provided for round screw heads
located on the front and rear of the Control Panel tubs. See notches illustrated in
Figure 2-7 .
20.94"
(53.2 cm)
45°
21.7"
(55.1 cm)
4.157"
(10.6 cm)
3.625"
(9.2 cm)
0.375"
(1.0 cm)
0.375"
(1.0 cm)
0347-02-22
8.625"
(21.9 cm) 0.50"
(1.25 cm)
0.22"
(0.5 cm)
6.50"
(16.5 cm)
9.50"
(24.1 cm)
0.375"
(1.0 cm)
0.50"
(1.25 cm)
0.2"
(0.5 cm)
10.2 "
(25.9 cm)
0.375"
(1.0 cm)
17°
Figure 2-6. Model 4000-3 Control Panel Side Dimensions (Flush Mount)