Tektronix DSA8300, Programmer'S Manual

Page: 130 / 455

Commands Listed in Alphabetical Order
DATa:DESTination
This command sets or queries the destination reference memory location for
storing waveform data that is transferred into the instrument by the CURVe
command.
Group Waveform Transfer
Syntax
DATa:DESTination {REF<x>}
DATa:DESTination?
Related Commands CURVe
WAVFrm?
DATa:STARt
DATa:STOP
Arguments
REF<X>
REF1 through REF8 are the reference memory locations where the
waveform will be stored. You cannot have a channel as a destination.
Examples
DATA:DESTINATION REF3
stores the incoming waveform data in Reference 3.
DATA:DESTINATION?
might return
DATA:DESTINATION REF8
as the reference
memory location that is currently selected.
DATa:ENCdg
This command sets or queries the format of the waveform data. This command
is equivalent to setting WFMOutpre:ENCdg, WFMOutpre:BN_Fmt, and
WFMOutpre:BYT_Or, as shown in the table below. Only signed, 4-byte integers
and
fl oating point values are supported. Changing the DATa:ENCdg parameter
will coerce WFMOutpre formatter commands accordingly. If ASCIi is selected,
the output will be formatted to
fl oating point or signed integer, based on how the
data is stored in the instrument.
Group Waveform Transfer
Syntax
DATa:ENCdg { ASCIi | RIBinary | FPBinary | SRIbinary |
SFPBinary }
DATa:ENCdg?
2-114 DSA8300 Programmer Manual