Tektronix AWG70001B, Installation And Safety Instructions

Page: 24 / 50

CAUTION. To avoid damage to the surface of the instrument, do not use any abrasive or chemical cleaning agents.
Use extreme care when cleaning the surface of the display. The display is easily scratched if excessive force is used.
1. Remove loose dust on the outside the instrument with a lint-free cloth. Use care to avoid scratching the front-panel display.
2. Use a soft cloth dampened with water to clean the instrument. If needed, use a 75% isopropyl alcohol solution as a cleaner.
Do not spay liquids directly on the instrument.
Power on the instrument
1. Connect the AC power cord to the rear of the instrument.
2. Use the front-panel power button to switch the instrument on.
The power button indicates four instrument power states:
■ No light – no power applied
■ Yellow – standby mode
■ Green – powered on
■ Flashing Red – over heat condition (instrument shuts down and cannot restart until internal temperature returns to a
safe level)
Install the instrument
8 AWG70000B Series Installation and Safety Instructions