Tektronix AWG70001A, Technical Reference

Page: 53 / 81

Brief procedures
Functional test
The purpose of the procedure is to con fi rm that the instrument functions properly.
The required equipment is listed below.
Table 2-1: Required equipment for the functional test
Item Qty. Minimum requirements Recommended equipment
Oscilloscope 1 ea. Bandwidth: 4 GHz or higher
4 channels Tektronix DPO70404C
Function generator 1 ea. 1 kHz, square wave, 5 V
p-p
output Tektronix AFG3021C
Signal analyzer
(required for Option AC
only) 1 ea. Bandwidth: 14 GHz or higher Tektronix RSA5126B
Adapter 3 ea TekConnect oscilloscope input to SMA input Tektronix TCA-SMA
50 Ω SMA cable 3 ea. DC to 20 GHz Tensolite 1-3636-465-5236
50 Ω SMA termination 3 ea. DC to 18 GHz Tektronix part number 015-1022-01
(one is supplied with the AWG70001A,
two with the AWG70002A).
50 Ω BNC cable 1 ea. Male connectors both ends Tektronix part number 012-0057-01
SMA-BNC adapter 3 ea. SMA female to BNC male connector Tektronix part number 015-0572-00
Planar Crown RF Input
Connector – 7005A-1 SMA
Female
(required for Option AC
only) 1 ea. Planar Crown RF Input Connector – Type N
to SMA Female
For use with Tektronix RSA5126B signal
analyzer Tektronix part number 131-8689-00
Test waveforms
The following table lists the test waveforms that are used for the functional
test. These are included on the instrument hard drive at:
C:\Program
Files\Tektronix\AWG70000\Samples\PV .
Table 2-2: Test waveforms
Waveform name Purpose
PV_Square.wfmx For the triggered output functional test
For the analog and marker functional test
Checking the analog and
marker outputs
Required equipment Prerequisites
Oscilloscope
Three TCA-SMA adapters
Three 50
Ω SMA cables
Three 50 Ω SMA terminations
None
AWG70000A Series and AWGSYNC01 Technical Reference 2–9