Tektronix AWG7000 Series, Service Manual

Page: 101 / 140

Troubleshooting
AWG7000 Series Service Manual
4-49
Calibration Error
To run the instrument calibration, do these steps:
1. Turn off all other applications.
2. From the menu bar, select System and then select Calibration... ; the
Calibration dialog box appears.
Figure 4-23: Calibration dialog box
151000015 Analog Level Diag CH2 5db attenuator gain balance failed. OUT10G OUT10G: K610, K710
151000016 Analog Level Diag CH2 5db attenuator gain balance failed. OUT10G OUT10G: K610, K710
151000017 Analog Level Diag CH2 10db attenuator gain balance failed. OUT10G OUT10G: K620, K720
151000018 Analog Level Diag CH2 20db attenuator gain balance failed. OUT10G OUT10G: K630, K730
151000019 Analog Level Diag CH2 filter 50mhz gain balance failed. OUT10G OUT10G: K660, K760
151000020 Analog Level Diag CH2 filter 200mhz gain balance failed. OUT10G OUT10G: K670, K770
151000021 Analog Level Diag CH2 amp gain balance failed. OUT10G OUT10G: U800
1520M0001 Marker Level Diag CH2 MARKER M offset failed. OUT10G U120,U170,U230,U240,U330,U340
1520M0002 Marker Level Diag CH2 MARKER M positive offset failed. OUT10G U120,U170,U230,U240,U330,U340
1520M0003 Marker Level Diag CH2 MARKER M negative offset failed. OUT10G U120,U170,U230,U240,U330,U340
1520M0004 Marker Level Diag CH2 MARKER M amplitude failed. OUT10G U120,U170,U230,U240,U330,U340
1520M0005 Marker Level Diag CH2 MARKER M amplitude correction
failed. OUT10G U120,U170,U230,U240,U330,U340
190000000 TekLink receive error Send= TR Recv= RV
TR:Transmition data
RV:Receive data
MIO MIO: U300
Table 4-6: Diagnostics error (cont.)
Error code Error log message Possible defect
on board Note